Marco Jet 6 Coffee Brewer

Ventilation Requirements

• Back: 70mm / 2.7”
• Sides: 50mm / 1.9”
• Ensure adequate clearance around the machine if installed in an enclosed cabinet.

Electrical Installation Procedure

• Model specifications: 1000851 - 2.8kW / 200-230V AC
• Always observe local regulations and standards during installation.
• Plug types:
  • UK: Supplied with a 3-pin plug.
  • EU: Supplied with a 2-pin CEE-7 plug.
  • US: Supplied with a suitable plug.
• Ensure a suitable mains power socket is within easy access for safe disconnection after installation.

Plumbing Installation Procedure

• Install the equipment in accordance with local plumbing and water regulations.
• Fit a stop valve and suitable fitting on a cold water line (e.g., 3/4” x 1/2” 311 or washing machine type stop valve).
• Use a food-grade inlet hose with a 3/4” BSP female elbow fitting to attach to the underside of the machine.
• Ensure the pre-attached sealing washer is fitted on both ends of the hose.
• Flush the water line and inlet hose by turning on the water and allowing several gallons to flow through to remove impurities and dust.
• Connect the right-angled tailpiece of the hose to the boiler's inlet valve (3/4” BSP), ensuring the sealing washer is fitted here as well.
• Turn on the water and check for leaks.
  Note: Avoid using a non-food-grade hose (e.g., a washing machine hose), as it may cause off-tastes, smells, and potential toxicity in the water.